Home :: Chevrolet :: C10
Recalls for Chevrolet C10 1994
Select a Chevrolet C10 1994 recall from the list:
- EXTERIOR LIGHTING
- certain aai motorsports combination lamps sold as replacement lamps for use on the above list passenger vehicles. combination lamps not equipped with amber side reflectors fail to conform with the requirements of federal motor vehicle safety standard no. 108,
- ENGINE AND ENGINE COOLING : ENGINE : DIESEL
- vehicle description: light duty pickup trucks, vans and motorhomes equipped with electronically fuel injected 6.5l diesel engine. this is not a safety recall in accordance with federal regulation part 573. however, it is deemed a safety improvement campaign by the agency. the campaign will improve the overall driveability of these vehicles.
- SEATS
- the seat recliner to seat frame attaching bolts on these vehicles could loosen, fatigue and fracture, allowing the seat back to suddenly recline.
- VISIBILITY : WINDSHIELD WIPER/WASHER
- vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.
- SERVICE BRAKES, HYDRAULIC : SWITCHES : BRAKE LIGHT
- vehicle description: pickup trucks, crew cabs, utility trucks and sport utility vehicles. these vehicles were built with the polarity of the wiring for the zero adjust brake switch reversed from what was specified on the switch drawing. with the reversed polarity, the contacts in the brake switch can wear out prematurely. the brake switch will perform normally until the brake switch contacts wear out, resulting in loss of the brake lamps without any warning to the driver.
- SEATS
- the seat recliner to seat frame attaching bolts on these vehicle could loosen, fatigue and fracture, allowing the seat back to suddenly recline.
- SEAT BELTS : FRONT
- these vehicles were built with front seat belt systems with no energy management loops and may not meet the head injury criteria requirements of fmvss no. 208, "occupant crash protection."
- SEAT BELTS : FRONT
- if both the lap-belt and shoulder-belt energy management loops on the front seat belt assemblies release at or near the same time, acceleration forces can cause the buckle release mechanism to activate and allow the buckle to separate from the latch.
- SERVICE BRAKES, HYDRAULIC : PEDALS AND LINKAGES
- the brake pedal push rod retainer is missing, mispositioned or not properly seated.
- VISIBILITY : WINDSHIELD
- the windshields were installed with incorrect windshield opening pinch-weld-flange primer. this primer will not properly etch the painted surface of the flange, allowing the windshield to separate from the vehicle during a collision. this does not comply with the requirements of fmvss no. 212, "windshield mounting."
- SUSPENSION : FRONT : CONTROL ARM : LOWER ARM
- trucks were assembled with the left-hand lower control arm to frame rear nut tightened below the specified torque. low torque on this nut may allow the attachment bolt to loosed and subsequently fatigue and break. the bolt breakage can cause the left hand control arm to separate from the frame.
- SEATS
- the seats have been assembled without bolts that connect the upper slave hinge to the seat back frame, or without bolts that connect the seat to the seat adjuster. in either case, the vehicles fail to conform to fnvss no. 207, "seating systems."