Home :: Chrysler :: Sebring
Recalls for Chrysler SEBRING 1996
Select a Chrysler SEBRING 1996 recall from the list:
- SERVICE BRAKES, HYDRAULIC : POWER ASSIST
- the power brake booster vacuum hose was improperly installed on the intake manifold vacuum nipple.
- SUSPENSION : FRONT : CONTROL ARM : LOWER BALL JOINT
- vehicle description: passenger vehicles. if the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude.
- FUEL SYSTEM, GASOLINE : DELIVERY : FUEL PUMP
- certain tigas fuel pump modules manufactured between june 1 and september 24, 2006, sold under various brand names and p/nos. these fuel pump modules are sold as aftermarket for use in certain daimlerchrysler vehicles listed above. silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper valve restricting the flow of fuel to the fuel pump module.
- FUEL SYSTEM, GASOLINE : DELIVERY : FUEL PUMP
- certain airtex fuel pump modules, p/nos. e7089m, e7094m, e7113m, and e7129m, manufactured between june 1 and september 24, 2006. these fuel pump modules were sold as aftermarket for use in certain daimlerchrysler vehicles listed above. silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper valve restricting the flow of fuel to the fuel pump module.
- FUEL SYSTEM, GASOLINE : DELIVERY : FUEL PUMP
- certain airtex fuel pump module assemblies, p/n e7081h, sold for use as replacement equipment for the vehicles listed above. the wall of the flared fitting of the fuel pump is not thick enough to prevent the mating threaded fittings from bottoming out before an adequate seal is achieved. this condition may result in leakage of fuel at the connection of the vehicle fuel line and the fuel pump module assembly.
- VEHICLE SPEED CONTROL
- on certain passenger vehicles equipped with 2.5l v6 engines, the throttle control cable can fray causing the throttle to bind or stick.
- EXTERIOR LIGHTING
- sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. these headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.
- SUSPENSION : FRONT : CONTROL ARM : LOWER BALL JOINT
- vehicle description: passenger vehicles. if the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude. also, mmc has added the potential of leaking moisture, which can cause the ball stud to corrode.
- STRUCTURE : BODY : ROOF AND PILLARS
- this is not a safety recall in accordance with the safety act. however, it is deemed a safety improvement campaign by the agency. vehicle description: passenger vehicles. if the convertible top cover is not installed correctly, it can separate unexpectedly from the vehicle while driving.
- POWER TRAIN : AUTOMATIC TRANSMISSION : PARK/NEUTRAL START SWITCH
- vehicle description: passenger vehicles equipped with automatic transmissions. the adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. a combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.
- VISIBILITY : REARVIEW MIRRORS/DEVICES
- the electrical contacts in the power mirror switch can accumulate road salt due to water entering into the switch.
- SUSPENSION : FRONT : CONTROL ARM : LOWER BALL JOINT
- vehicle description: passenger vehicles. the lower control arm ball joint can separate due to loss of lubrication.