Home :: Chrysler :: Sebring
Recalls for Chrysler SEBRING 1997
Select a Chrysler SEBRING 1997 recall from the list:
- FUEL SYSTEM, GASOLINE : DELIVERY : FUEL PUMP
- certain airtex fuel pump module assemblies, p/n e7081h, sold for use as replacement equipment for the vehicles listed above. the wall of the flared fitting of the fuel pump is not thick enough to prevent the mating threaded fittings from bottoming out before an adequate seal is achieved. this condition may result in leakage of fuel at the connection of the vehicle fuel line and the fuel pump module assembly.
- FUEL SYSTEM, GASOLINE : DELIVERY : FUEL PUMP
- certain airtex fuel pump modules, p/nos. e7089m, e7094m, e7113m, and e7129m, manufactured between june 1 and september 24, 2006. these fuel pump modules were sold as aftermarket for use in certain daimlerchrysler vehicles listed above. silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper valve restricting the flow of fuel to the fuel pump module.
- FUEL SYSTEM, GASOLINE : DELIVERY : FUEL PUMP
- certain tigas fuel pump modules manufactured between june 1 and september 24, 2006, sold under various brand names and p/nos. these fuel pump modules are sold as aftermarket for use in certain daimlerchrysler vehicles listed above. silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper valve restricting the flow of fuel to the fuel pump module.
- EXTERIOR LIGHTING
- certain tradesonic combination lamps sold as replacement lamps for use on the above listed passenger vehicles. combination lamps not equipped with amber side reflectors fail to conform with the requirements of federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.
- VEHICLE SPEED CONTROL
- on certain passenger vehicles equipped with 2.5l v6 engines, the throttle control cable can fray causing the throttle to bind or stick.
- SUSPENSION : FRONT : CONTROL ARM : LOWER BALL JOINT
- vehicle description: passenger vehicles. if the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude. also, mmc has added the potential of leaking moisture, which can cause the ball stud to corrode.
- SEATS : FRONT ASSEMBLY : HEAD RESTRAINT
- the headrest guide bracket was improperly welded to the seat back frame on the passenger side seat back assemblies only.
- STRUCTURE : BODY : ROOF AND PILLARS
- this is not a safety recall in accordance with the safety act. however, it is deemed a safety improvement campaign by the agency. vehicle description: passenger vehicles. if the convertible top cover is not installed correctly, it can separate unexpectedly from the vehicle while driving.
- SUSPENSION : FRONT : CONTROL ARM : LOWER BALL JOINT
- vehicle description: passenger vehicles. the lower control arm ball joint can separate due to loss of lubrication.
- POWER TRAIN : AUTOMATIC TRANSMISSION : PARK/NEUTRAL START SWITCH
- vehicle description: passenger vehicles equipped with automatic transmissions. the adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. a combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.