Home :: Jeep :: Cherokee
Recalls for Jeep CHEROKEE 1990
Select a Jeep CHEROKEE 1990 recall from the list:
- SERVICE BRAKES, HYDRAULIC : FOUNDATION COMPONENTS : DISC : ROTOR
- vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. the front disc brake rotors can experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion can eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
- VEHICLE SPEED CONTROL : ACCELERATOR PEDAL
- vehicle description: multipurpose passenger vehicles equipped with automatic transmissions. this is not a safety recall in accordance with federal regulation 573. however, it is deemed a safety improvement campaign by the agency. drivers can mistakenly step on the accelerator pedal when they intend to step on the brake pedal.
- SERVICE BRAKES, HYDRAULIC : FOUNDATION COMPONENTS : HOSES, LINES/PIPING, AND FITTINGS
- improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system can cause detachment of the hose from the abs system, and discharge of hydraulic fluid.
- VEHICLE SPEED CONTROL : CRUISE CONTROL
- malfunction of fuel injection system throttle postition sensor could cause intermittent high engine idle speed immediately after starting engine.
- EXTERIOR LIGHTING
- sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. these headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.
- SERVICE BRAKES, HYDRAULIC : FOUNDATION COMPONENTS : HOSES, LINES/PIPING, AND FITTINGS
- there may be hydraulic fluid contamination from condensation formation that can plug the abs brake booster pump filter; stress corrosion of the master cylinder snap ring has been traced to chlorine leaking from the low pressure hydraulic hose which may cause it to break; front brake hose to tire interference which may cause failure of the brake hose.
- SERVICE BRAKES, HYDRAULIC : ANTILOCK
- vehicle description: vehicles equipped with antilock brake system (abs). the antilock brake system (abs) hydraulic control unit can experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.
- EXTERIOR LIGHTING
- certain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.
- EXTERIOR LIGHTING : HEADLIGHTS
- dope, inc. is recalling 42,540 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. these headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.