Home :: Jeep :: Grand Cherokee
Recalls for Jeep GRAND CHEROKEE 1993
Select a Jeep GRAND CHEROKEE 1993 recall from the list:
- EXTERIOR LIGHTING
- certain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.
- POWER TRAIN : AUTOMATIC TRANSMISSION : LEVER AND LINKAGE : FLOOR SHIFT
- on certain sport utility vehicles, if a driver has not placed the shifter lever fully into the "park" position and leaves the vehicle running, the vehicle may unexpectedly move rearward after seeming to be stable.
- VEHICLE SPEED CONTROL : ACCELERATOR PEDAL
- vehicle description: multipurpose passenger vehicles equipped with automatic transmissions. this is not a safety recall in accordance with federal regulation 573. however, it is deemed a safety improvement campaign by the agency. drivers can mistakenly step on the accelerator pedal when they intend to step on the brake pedal.
- SERVICE BRAKES, HYDRAULIC : FOUNDATION COMPONENTS : DISC : ROTOR
- vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. the front disc brake rotors can experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion can eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
- SEAT BELTS : REAR
- this is not a safety recall in accordance with federal regulation 573. however, it is deemed a safety improvement campaign by the agency. the center rear seat belt buckle may not be accessible when the right (passenger) side of the rear seat back is folded down in the cargo stowage position.
- STRUCTURE : BODY : HATCHBACK/LIFTGATE
- grease applied to the liftgate latch rubber bumpers to ease component assembly caused the bumper to swell, interfering with the movement of the liftgate latch pawl. this prevents the liftgate latching when closed and difficult to open when latched.
- SUSPENSION : FRONT
- the eccentric cam adjuster bolts in both front lower suspension arm-to-front axle bracket attachments may fail due to assembly misalignment.
- SERVICE BRAKES, HYDRAULIC : PEDALS AND LINKAGES
- the retainer clip which secures the master cylinder input rod to the brake pedal was not installed properly, and could work loose.
- STEERING : WHEEL AND HANDLE BAR
- the molded plastic pin which connects the upper steering column shaft and the lower column shaft may have been sheared prior to installation of the steering column assembly into the vehicle. if this occurred, the upper steering shaft will separate from the lower steering shaft.