Home :: Mercury :: Marquis
Recalls for Mercury MARQUIS 1979
Select a Mercury MARQUIS 1979 recall from the list:
- SERVICE BRAKES, HYDRAULIC : PEDALS AND LINKAGES
- the involved vehicles were produced with brake push-rod to brake pedal retaining pins which were not heat-treated as specified. this could allow the brake pedal to become disengaged from the push-rod.
- SERVICE BRAKES, HYDRAULIC : FOUNDATION COMPONENTS : HOSES, LINES/PIPING, AND FITTINGS
- some of these vehicles were produced with misindexed front brake hoses which could contact a tire or wheel in a full-turn condition. chafing and wear to the brake hose could result in loss of brake fluid and front wheel braking capability.
- STEERING : WHEEL AND HANDLE BAR
- the lower steering shaft assemblies contain coupling rivet pins which were not riveted securely enough during manufacture. consequently one or both of the pins could loosen from the flange of the flexible coupling during vehicle operation. if one pin is loose, free play would result. if both pins work loose, loss of steering control would occur. also, the shaft assembly may not contain a metal reinforcement between one or both of the rivet pins and the rubber flexible coupling. as a result, the rubber flexible coupling could tear and produce a noise or loose feeling in the steering system.
- SERVICE BRAKES, HYDRAULIC : FOUNDATION COMPONENTS : HOSES, LINES/PIPING, AND FITTINGS
- ELECTRICAL SYSTEM : FUSES AND CIRCUIT BREAKERS
- the windshield wiper and washer system contains an incorrect 6 amp circuit breaker instead of the 8.25 amp circuit breaker. if the system is heavily loaded, as in the case of a partially dry windshield, the motor current may exceed the 6 amp breaker"s capacity. this would cause the breaker to open, which would result in wiper/washer failure.
No consumer complaints found for this model and year